
Diagnosis Before Quote
We meter the elements, test the thermocouple and photograph the fittings before we price anything. You get a written scope with part numbers, so you can compare it against any other quote you have.
One call covers the whole job, from a dripping TPR valve to a full tankless conversion. If you have been searching water heater repair near me Meridian MS at 10 p.m. with a wet floor, we answer, walk you through shutting off the supply, and get a tech rolling. Every service below is priced upfront before we start.

One call covers the whole job, from a dripping TPR valve to a full tankless conversion. If you have been searching water heater repair near me Meridian MS at 10 p.m. with a wet floor, we answer, walk you through shutting off the supply, and get a tech rolling. Every service below is priced upfront before we start.
Water Heater RepairWe diagnose no-hot-water calls across Meridian, testing the thermostat, heating element and thermocouple before quoting. Most repairs finish in two to four hours with parts on the truck, and we verify the fix with a full heat cycle before we pack up.
Water Heater ReplacementWhen a 12-year-old tank is rusting from the inside, replacement beats another repair. We haul out the old unit, set the new one on a drain pan, reconnect with dielectric unions and flex connectors, and light it off the same day.
Tankless Water Heater InstallationTankless installs in Meridian need correct gas sizing and venting, not just a wall bracket. We run the dedicated line, mount the unit, set the recirculation pump if you want instant hot water, and commission it against the manufacturer spec sheet.
Tankless Water Heater RepairTankless units fail on scale, not tanks. We pull the descaling pump through the heat exchanger, clear the inlet filter, check the flow sensor and flame rod, and restore consistent temperature at every fixture in the house.
Water Heater Maintenance & Tune-UpsAn annual flush removes the sediment that shortens tank life in hard Mississippi water. We drain the tank, inspect the anode rod, test the T&P valve with a gauge, and check the vent pipe for backdrafting before we refill.
Emergency Water Heater ServicesA tank that lets go at 2 a.m. does not wait for business hours. We take the call, talk you through shutting the inlet valve and killing the gas or breaker, then get a technician to your address with a replacement tank option.
Gas Water Heater RepairPilot light outages, dirty thermocouples and clogged burner tubes are the usual culprits. We clean the burner assembly, test gas pressure at the valve, and confirm the flue is drafting correctly before we call the job done.
Electric Water Heater RepairElectric tanks fail quietly. We meter both elements, test the upper and lower thermostats, check the dip tube, and confirm the breaker and wire gauge match the load before replacing anything.
Hybrid Heat Pump Water Heater InstallationHeat pump water heaters cut run cost but need 700 cubic feet of air and a condensate path. We site the unit correctly, run the drain line, set the operating mode, and walk you through the app controls.
Water Heater Leak RepairNot every leak means a new tank. We isolate whether the water is coming from the TPR valve, the drain valve, a fitting or the tank shell itself, then repair the source or tell you straight that the tank is done.
Water Heater Thermostat & Element RepairLukewarm water usually points to a failed lower element or a thermostat that has drifted. We test resistance, swap the part, and reset the temperature to 120 degrees to limit scalding and mineral buildup.
Water Heater Pilot Light & Ignition RepairA pilot that will not stay lit is often a thermocouple or a draft problem, not a gas supply issue. We test the thermocouple millivolt output, clean the orifice, and verify the flame is stable under load.
Anode Rod ReplacementThe anode rod is the sacrificial part that keeps your tank from rusting through. We pull the old rod, inspect the tank threads, install a new magnesium or aluminum rod, and reseal the port with fresh thread tape.
Sediment Flush & DescalingPopping and rumbling means sediment is cooking on the burner plate. We flush the tank through the drain valve, then run a descaling pump on tankless units to strip scale from the heat exchanger.
Expansion Tank Installation & RepairA failed expansion tank spikes pressure and stresses every fitting in the system. We check the charge with a pressure gauge, replace the bladder tank, and confirm the TPR valve is not weeping after the swap.
TPR Valve ReplacementA TPR valve leaking at the discharge pipe is a safety issue, not a nuisance. We match the valve rating to the tank, install it to code, and test the lever action before we leave the property.
Water Heater Drain Pan InstallationA pan with a routed drain line turns a tank failure into a minor cleanup instead of a flooded floor. We set the pan level, connect the drain to a safe discharge point, and seal the seams.
Water Heater Venting & Flue RepairBackdrafting pushes carbon monoxide into the room. We inspect the flue pipe, check the slope and clearances, brush the flue, and correct any single-wall venting that does not meet code.
Recirculation Pump InstallationIf you wait 40 seconds for hot water at the far bathroom, a recirculation pump fixes it. We tie it into the return line, set the timer, and balance the loop so the whole house gets hot water fast.
Water Heater Code Compliance & PermittingReplacement work in Meridian needs a permit and an inspection. We pull the permit, install to Uniform Plumbing Code and International Plumbing Code standards, and meet the inspector on site so the job closes clean.
Old Water Heater Removal & DisposalWe drain, disconnect and haul the old tank out, including the venting and fittings. The unit leaves your property the same day, and we recycle the steel rather than leaving it on the curb.
Water Heater Inspections & Safety ChecksA full inspection covers the anode rod, TPR valve, venting, gas connections and pan. We use an inspection camera on hard-to-see fittings and hand you a written report with photos of anything that needs attention.
Commercial Water Heater ServicesRestaurants, salons and small offices in Meridian cannot run cold. We service commercial tanks and boilers, size recovery rates to your demand, and schedule work around your operating hours to keep you open.
Boiler & Indirect Water Heater ServicesIndirect tanks tied to a boiler need the coil and controls checked together. We test the zone valve, aquastat and circulator, flush the coil, and confirm the boiler is holding temperature under load.From the first phone call to the final heat cycle, you know what is happening and what it costs. No waiting around for a callback that never comes.

You describe the symptom, we ask about age, fuel type and whether water is on the floor. If it is an emergency, we walk you through shutting off the supply and the gas or breaker right then.

The technician meters the elements, tests the thermocouple and TPR valve, and checks the anode rod and venting. You get readings, not guesses, and a written scope before any work begins.

If a $200 part fixes it, we do that. If the tank shell is compromised, we show you the corrosion and quote a replacement with the permit and haul-away included.

We refill, purge the air, run a full heat cycle and check every fitting for weeping. You get the old parts, the paperwork and a walkthrough of the new settings before we leave.
We are a plumbing contractor, not a call center. The person who answers knows what a TPR valve is, and the technician who shows up has the parts to finish the job the same day in most cases.


Common Rheem, A.O. Smith and Bradford White parts ride with us: thermostats, elements, anode rods, TPR valves and flex connectors. That means most repairs finish in one visit instead of two.
Every replacement is permitted and inspected to Uniform Plumbing Code and International Plumbing Code standards. We also hold EPA Section 608 handling credentials for refrigerant work on hybrid heat pump units.
Straight answers to the questions we get on the phone every week in Meridian.
Still wondering? +16015310808

Most repairs run $129 to $650 depending on the part. A thermostat or element swap sits at the low end, while an anode rod, TPR valve or expansion tank job lands higher. Full replacement in Meridian runs $1,150 to $2,400 with the permit and haul-away included. We quote before we start.
The right company diagnoses before quoting and carries the parts to finish in one visit. Ask whether they meter the elements, test the thermocouple and check the anode rod, and whether they pull a permit for replacements. We do all of it and hand you the readings and a written scope.
We take emergency calls around the clock for active leaks and no-hot-water situations. When you call, we walk you through shutting the inlet valve and killing the gas or breaker, then dispatch a technician. Most emergency calls in the 39301 and 39307 ZIP codes get a same-day visit.
Confirm they are a licensed plumbing contractor, ask for the permit on replacements, and get the scope in writing with part numbers. A pro should test the TPR valve and venting, not just swap a part. If they cannot explain why the failure happened, keep calling.
Match the tank to your household size and fuel type, and make sure the quote covers the permit, drain pan, flex connectors and disposal. Tankless makes sense if you want endless hot water and have the gas capacity. We size it to your demand and show you the math.
Cold shower, wet floor or a pilot that will not stay lit? Call Meridian Water Heater Pros at +16015310808. We diagnose the real failure, quote it upfront, and get hot water back the same day in most cases.
Reach us at +16015310808 and you will talk to someone who knows water heaters, not a script. We book same-day windows for most of Meridian and keep the line open for emergency leaks. If you are outside the usual ZIP codes, call anyway and we will tell you straight whether we can get to you.